Community Funtime Challenge
This is a challenge where you have to design a phone holder for 3D printing while following these rules:
1. Must print in under 6 hours on an old Ender 3
2. Must have minimal or no support
3. Must have minimal assembly required
4. Must be aesthetically pleasing
​
How your model will be scored (out of 15):
1. Print time (3 Points max):
    More Than 6 Hours = 0 Points
    Less Than 6 Hours = 1 Point
    Less Than 4 Hours = 2 Points
    Less Than 2 Hours = 3 Points

2. Post-processing (1 Point Max):
    If post-processing is required, no points will be awarded

3. Assembly (3 Points Max):
    More than 6 Pieces = 0 Points
    Less Than 5 Pieces = 1 Point
    Less Than 3 Pieces = 2 Points
    Less Than 2 Pieces = 3 Points

4. Aesthetics (3 Points Max):
    This will be based on a rating out of 3 by the judges

5. Community Poll (5 Points Max):
    Top Vote = 5 Points
    Second vote = 3 Points
    Third Vote = 1 Point
​
Rewards:
    First Place: $20 coupon off all our services
    Second Place: $15 coupon off all our services
    Third Place: $10 coupon off all our services

Terms And Conditions​

All winners will be elegible to receive one 3D printed copy of their design in the mail on request.

If you don't make the top three then you are able to get a free printed version of your design delivered to you provided that you pay the postage fees

We will NEVER use your designs to generate profit without permission. We acknowledge that the 3D models designed by you are your property.

All models submitted will be cross-checked for plaigarism.
Claiming someone else's model will not be permitted and will result in a permanent ban from all future competitions.

Submission period ends on May 30th 2026
Judging will commence after all submissions have been printed